Reduce Scrapping and Smelting, Promote Component Reuse > Unpowered, Hand Tools
> Repair Tools and Wrenches
> DuPage County
> Thomas & betts liquidtight metal conduit fittings 3/4"
Thomas & betts liquidtight metal conduit fittings 3/4"
T&B Thomas & Betts Liquidtight Flexible Metal Conduit Fittings CAT #: 5333 (11)
3/4" Insulated Liquidtight Connector; Body, Gland, Locknut and Ground Cone Material-Steel with Electro Zinc Plating and Chromate Coating. Sealing ring and Insulator Material-Thermoplastic, Sealing Gasket Material-Stainless Steel and Buna N. For use with Flexible Metal Conduit.
* Used where flexible metal raceway is installed in outdoor or indoor locations where exposed to continuous or intermittent moisture.
* To positively bond conduit to box or enclosure.
* Ability to install quickly with low torque effort.
* Ground cone design offers following advantages: (1) Compresses metallic convolutions; provides high quality ground contact with low impedance and high raceway holding power (A). (2) Single helical thread on ground cone is easy to install without cross thread; accepts variations in raceway diameters and convolution pitch (B). (3) Rolled over edge protects conductors (C). Sealing ring design has following exclusive features: (1) Grips and seals at leading and trailing edge will not abrade raceway jacket (D). (2) Provided with grooves on inside diameter for anti-sleeving (E). (3) Shoulders on both ends for extra sealing (F). (4) Symmetrical shape assures foolproof assembly.
* Can be disconnected and reused.
* Watertight/oil tight installation at box or enclosure termination is assured by: (1) External taper thread hub on 5331 series and use of sealing gasket 5262 series (G). (2) Captivated sealing O ring on 5361 series (H). (3) Taper tapped hole on 5271 series.
* Suitable for use in Class I Division 2, Class II Division 1 and 2 and Class III Division 1 and 2 Hazardous Locations per N.E.C. Section 500.
* Suitable as a grounding means per N.E.C. Section 351-9 (up to 1b" trade size on).
* d" & 1b" sizes Laboratory tested to carry ground fault current of up to 1000 amps RMS with duration of fault current 3 cycles.
* Conforms with JIC requirements.
* Available with imperial, I.S.O. & PG threaded hub.
* Finish: Electro Zinc Plated-Chromate Coated
* Conduit Size (inches): 3/4
