Reduce Scrapping and Smelting, Promote Component Reuse > Engine Powered
> Turbine
> Make extension & compression springs diy winder plans
Make extension & compression springs diy winder plans
Make your own Springs / Winder Plans
An Original 1956 how-to build article / plans that was removed from a vintage magazine.
Excerpt: "You can eliminate, once and for all, the problem of quickly locating a small spring of just the right size and type for the job at hand with this spring winder. The winder plus 3 or 4 coils of spring wire of various wire gage sizes will enable you to wind either right or left hand compression or extension springs up to 5/16 in. diameter. Spring coil spacing of 1/8 in. is possible for compression springs, and the length of the springs you can make is limited only by the length that you make the mandrels on which the springs are wound."