Reduce Scrapping and Smelting, Promote Component Reuse > Engine Powered
> Gasoline Powered
> Cook County
> Used
> Infrared remote control for icom transceivers
Infrared remote control for icom transceivers
This is a new SWL IR Remote, an infrared remote control unit for ICOM Receivers and Transceivers with CI-V protocol. You can now control your ICOM Transceiver from your easy chair using the Universal Remote. This product comes with a one-year warranty.
The SWL IR Remote consists of a small control unit that connects to the computer interface (CI-V port) of your Transceiver with an included cable. It uses the built in CI-V computer control commands to control your Transceiver using the included Universal Remote. The included Universal Remote is a big button remote that is pre-programmed for the SWL IR Remote.
The SWL IR Remote comes complete with AC wall adapter, Universal Remote with two AAA batteries, and CI-V cable. You do not need the CT-17. The Printed Operating Manual and Quick Reference Commands Guide are included.
ICOM Receivers and Transceivers that will work with the SWL IR Remote: 703, 706, 706MkII, 706MkIIG, 707, 718, 725, 726, 728, 729, 735, 736, 737, 738, 7400, 746, 746Pro, 751A, 756, 756Pro, 756ProII, 756ProIII, 761, 765, 775DSP, 7800, 781, 821H, 910H, R-75.
CI-V Command Codes implemented in the SWL IR Remote.
SWL IR Remote for ICOM Receivers and Transceivers Features:
* Turn Receiver/Transceiver on and off. Your Receiver/Transceiver must support the Power on/off CI-V command.
* Enter frequency directly to 1Hz. Your Receiver/Transceiver must support frequency entry to 1Hz.
* Increase or decrease frequency using CH +/- in steps of 1Hz, 10Hz, 100Hz, 1kHz, 5kHz, 9kHz, 10kHz, 100kHz, and 1MHz.
* Set up to five (5) User Tuning Steps. Useful for detuning frequencies by one half of filter bandwidth or use a very small frequency step to quickly zero-beat in SSB mode.
* Recall last directly entered frequency.
* Directly select memory channels 1-99.
* Move up and down through memory channels using CH +/-.
* Start and Stop programmed and memory scans.
* Move memory frequency and mode to VFO.
* Write VFO frequency and mode to currently selected memory.
* Toggle between AM, LSB, USB, FM (configurable), and CW (configurable).
* Select VFO or Memory mode.
* Radio baud rate (1200, 4800, 9600, or 19200).
* Enable/Disable FM and CW modes in mode selections.
* Frequency pacing. You can control the pacing of frequency up and down. This is how fast the frequency changes when you hold the CH+/- keys.
* Define up to five (5) User Tuning Steps.
* Status LED that shows communications status, settable parameter entry, and clear key operation.
* Remote control interface unit.
* CI-V Cable for connecting to Transceiver.
* Universal Remote with batteries.
