Reduce Scrapping and Smelting, Promote Component Reuse > Engine Powered
> Diesel
> Cook County
> Used
> 3495 weldcraft ahp-20-25 tig torch package 159.99
3495 weldcraft ahp-20-25 tig torch package 159.99
POWER CORD START-UP SAFETY SAF-START 120V 15A
When a SENSING-SAF-START is installed on any equipment and there is an electrical power interruption to the equipment, the SENSING-SAF-START will open the circuit so when the power source is restored, the SENSING-SAF-START will prevent the equipment from restarting. The SENSING-SAF-START will not reset until the equipment switch has been turned "off". There is a sensing circuit within the new SENSING-SAF-START that sends a signal up to the equipment switch to see if it is in the "on" position. If the switch is still "on", the SENSING-SAF-START sounds a warning buzz when the reset button is depressed, and it will not close the circuit until the equipment switch is turned "off". Then, and only then, the SENSING-SAF-START will close the circuit, so the equipment will operate again.