Reduce Scrapping and Smelting, Promote Component Reuse > Complete Machines
> 1960 1980
> Cook County
> New
> Honeywell S8910U1000 universal replacement ignition
Honeywell S8910U1000 universal replacement ignition
One or Two Rod Hot Surface Ignition Control 4 or 7 second trial time and 4 or 7 second lockout timing
Universal Hot Surface Ignition Module is designed to provide easy field replacement of a wide range of hot surface ignition modules manufactured by Honeywell, Robertshaw and White-Rodgers. The S8910U Module provides operating control of a direct ignition system using a 120 Vac hot surface igniter.
Replaces many White-Rodgers, Robertshaw and Honeywell hot surface ignition models.
For 120 Vac (up to 5.0A) surface igniter (Norton 201/271 or equivalent).
For local (single rod) or remote (dual rod) rectification type flame sensing.
Contains easy-to-use instructions plus the accessories required to adapt the existing hot surface ignition module.
Provides one or three ignition trials (four-second or seven-second trials) per call for heat; prepurge of 32 seconds or less; up to 96 seconds between purge trial times.
Temperature range is -40 to +175 F (-40 to +79 C).
Provide electronic control of direct hot surface ignition systems used on gas fired furnaces, boilers, and other heating appliances.
The number of trials for ignition and trial time is determined by the selection tab. If a selection tab is not installed, the module will operate at four seconds trial time and one ignition trial.
Line Voltage (120 VAC) Hot Surface Element (Norton Model 201 or 270)
(2) 96 sec.- 3 trial mode only
