Reduce Scrapping and Smelting, Promote Component Reuse > Electric Powered
> Metalworking
> Mills
> Rocker milling clamps sherline taig etc. 4 pack
Rocker milling clamps sherline taig etc. 4 pack
Set of 4 symetrical hold down clamps (see left photo). Screws and washers and blocks are not included with this set. T-nuts are available separately if needed for $1.25 each (please check other items, or ask). This would be a great start, and then add stacking blocks later if you find you need the extra height. These are extremely handy little clamps for holding work pieces down on a milling table, tooling plate or fixture. The slot allows for a certain amount of lateral reach necessary for use with tooling plates. The self adjusting height is a real time/frustration saver. Optional range extender stacking blocks are available (please check other items, or ask).
Again their compactness make them especially ideal for machines with limited table or tooling plate surface area.
- self adjusting height 0 to 1/2" without blocks
- 1-1/2" with two blocks per clamp (sold separately)
