Reduce Scrapping and Smelting, Promote Component Reuse > Complete Machines
> Pre 1900
> 12 24 48 volt dc motor etek mt/pattern permanent magnet
12 24 48 volt dc motor etek mt/pattern permanent magnet
Fits on most common Etek bolt patterns and mounts
Vertical Stator Design (Magnets on BOTH sides of the stator)
Worlds most powerful motor for its weight to hp ratio!
Over one hp per lb. / 28 horse power maximum - See details below
The next revolution in direct drive wind turbine technology!
LOTS OF LOW END POWER GENERATION ABILITY!
Permanent Magnet Motor /Generator
NO EXPENSIVE CONTROLLER REQUIRED
No expensive motor controller needed -
Brush technology is older but they are very
quick and simple to replace in the field AND
brushed motors convert more electricity into
usable horsepower! - 94% Electric Efficiency!
http:// /pages/millipak4Q.html
http://www.4qd.co.uk/prod/4qd.html
* 7.91" diameter / 5.64" length
* 7/8" shaft with 3/16" keyway by 1.75" long (threaded center)
* Torque constant: 1.14 in-lb/Amp (0.13 Nm/Amp)
* 12V to 48V (has been run up to 96V / 45 sec. max. / 25 hp)
* 72 RPM per volt (3456rpm @ 48V / continuous duty)
* Can be used as a generator, makes power when turned (Requires 120 amp blocking diode)
* Great for VERY low voltages at high amp loads
* Perfect for building simple, cheap and dependable low voltage wind turbines.
* A put-up and forget design! Expect decades of dependable service life.
* Rain, ice and weather proof electronics.
* 10 horsepower continuous duty at 48 volts.
* Max motor currents: 330A for 2 minutes / 480A for 45 seconds.
* 10 horsepower max at 48 volts continuous duty!
* 14 horsepower max at 60 volts continuous duty with optional air cooling port.
* Works for both CW or CCW rotations.
* Epoxy/Lam rotor efficiency = 94% (Brushed motors convert more electricity into usable horsepower)
* Weighs 22 lbs. / Dimensions - 8"X 9"X 9"
* (From now, I enhanced the package, because one motor was broken in transit, so the weight now is 11.20KG/24.64Ibs)
WARNING: this motor is NOT an ordinary motor, and should be handled with GREAT care.
Do not allow motor to get over heated!
It is very capable of serious power and should always be completely secured before applying any power to it.
Power curve for both motor and generator usages
(Note: When used as a generator a MIN. 100 Amp blocking diode is needed!)
The #PMG226 is a Hydrogen Appliances Exclusive! Only available here.
(Ratings are based at time of high load)
(This PMG is recommended for experienced AE designers only!)
The Pan Cake Motor includes a 90 day repair only warranty.
Photos of actual motor! Very clean! Very well built!
BUILD ELECTRIC CARS / INVENT ELECTRIC BOATS / DESIGN ELECTRIC MOTORCYCLES
We want you to use these motors in your product designs to help mankind as we slowly run out of cheap fossil fuels
400 Mile Range Plug-in Electric Car Using Dual Pan Cake Motor Motors
Battery pack is 900 x Li-ion computer batteries / Weight 1200 lbs.
Lasts for 3700 charge cycles or 15 years of commuter driving.
Plug-in and get your fuel for only a .25 per gallon price equivalent!
In 10 years from now this is how 80% of us will be driving, Electric!
BE SURE TO USE LARGE GAUGE "00" WIRES ESPECIALLY ON 12 VOLT ENGINE DRIVEN PMG's
PMG's produce unregulated D.C. voltage and may require a charge controller for smaller batteries banks or non-grid connected applications.
It is very capable of serious power and should always be completely secured before applying any power to it!!
"A Real Power House for electric power generation from wind!"
To give you engineering types some idea of how unusually hyper the #PMG226 is, try this test;
Short out the power leads of the #PMG226 through an amp meter in line and try to turn the shaft by hand. While under a full load the shaft seems almost seized BUT during your fatiguing attempt to turn the shaft you will have produced well over a 35 amp reading on the amp meter!!!
You say 35 amps just by turning the shaft by hand? YES! (This test may require vise-grip pliers for persons with weak grips)
That's 35 amps at well under 1 RPS - WOW! Not bad for a direct drive unit!
At last, a permanent magnet generator that does not require a gear box!
Produce power at direct coupled wind turbine shaft speeds as low as 60 RPM!
Designed to be directly mounted on 8 to 12 foot in diameter high speed wind turbine propellers.
For extreme racing applications you may wish
to add a stream of compressed air at this point ->
2 CFM@50 PSI for cooling rotor in extreme high amperage situations
BE SURE TO USE LARGE GAUGE "00" WIRES
ESPECIALLY ON 12 VOLT ENGINE DRIVEN PMG's
This motor is NOT an ordinary motor
and should be handled with GREAT care.
It is very capable of serious power and should always
be completely secured before applying any power to it!!
The Pan Cake Motor includes a 30 day repair only warranty.
Over heated motors will not be warranted.
Be sure to provide adequate ventilation and not run to hot!!
